JVC AX-V55BK manual Connecting the Power Cord, Putting Batteries in the Remote Control, English

Connecting the Power Cord

	Before plugging the amplifier into an AC outlet, make sure that all connections have been made.
	1. Plug the power cord into an AC outlet.
POWER	2. Press POWER to set it in the _ON position.
	The STANDBY lamp lights up. A small amount of power is always consumed.
_ON ÑOFF
	To shut off the power completely:
	Press POWER to set it in the ÑOFF position.
	Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may
	cause noise or screen interference.

The difference between the POWER switch and the STANDBY/ON button

•The POWER switch is the mains supply switch, allowing the amplifier to connect to the mains supply. To shut off the power completely, press the POWER switch to set it in the ÑOFF position.

•The STANDBY/ON button is a functional on/off (standby) switch, and does not disconnect the amplifier from the mains supply. A small amount of power is consumed even in standby mode for the amplifier to accept signals from the remote control.

Notes:

The preset settings such as sound adjustment may be erased in the following cases:

•When you press POWER to set it in the ÑOFF position.

•When you unplug the power cord.

•When a power failure occurs.

CAUTIONS:

•Do not touch the power cord with wet hands.

•Do not pull on the power cord to unplug the amplifier. When unplugging the amplifier, always grasp the plug itself so as not to damage the cord.

Putting Batteries in the Remote Control

Before using the remote control, put the two supplied batteries in first. When using the remote control, aim the remote control directly at the remote sensor on the amplifier.

1.On the back of the remote control, press down on the battery cover and slide it out.

2.Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (–) to (–).

3.Slide the cover.

R6P (SUM-3)/AA (15F)

If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P (SUM-3)/ AA (15F) type dry-cell batteries.

CAUTIONS:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity indicated: (+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

English

Page 8