JVC CA-D452TR Presetting Stations, Changing the FM Reception Mode, Three Ways to Select a Station

		On the Remote Control
FM	AM	To tune in FM stations, press FM.
	or	To tune in AM stations, press AM.

COMPU PLAY

When FM or AM is pressed while the power is on standby, the power is automatically turned on.

Three Ways to Select a Station ——————————————

English

or

or

PTY/EON

DISPLAY MODE

Press TUNING DOWN 1or ÁTUNING UP on the MULTI CONTROL repeatedly to move from frequency to frequency until you find the one you want. (Manual Tuning).

OR

Press and hold TUNING DOWN 1or ÁTUNING UP on the MULTI CONTROL for a few seconds, the frequency starts changing on the display. When a station is tuned in, the frequency stops changing. (Auto Tuning).

OR

Possible only after presetting stations.

Press once and release 4P. DOWN or ¢P. UP on the MULTI CONTROL to go to the next preset station.

You can also use the Remote Control to tune in preset channels:

1.Press FM or AM so that you can receive the last station tuned in.

2.Select the station by entering the preset number in the number keys of the Remote Control.

• Example: for channel 5, press 5. For channel 15, press +10 then 5.

For channel 20, press +10, then 10. For channel 30, press +10 twice then 10.

–SELECT +

• After you have selected the preset number and the number appears, the broadcast frequency of the selected channel appears on the display.

	Presetting Stations
1	You can preset up to 30 FM stations and up to 15 AM (MW/LW) stations for the preset numbers.
	Note: In some cases, test frequencies have been already memorized for the tuner since the factory
	examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations
2	you want into memory by following the presetting method.
	1. Select a band by pressing FM/AM on the Unit.
		When using the Remote Control, press FM or AM.
or	2.	Press TUNING DOWN 1 or Á TUNING UP on the MULTI
		CONTROL to tune into a station.
	3.	Press SET.
		“SET” flashes for 5 seconds.
3 , 5		While it is still flashing, carry out the following procedure.
	4.	Press 4 P. DOWN or ¢ P. UP on the MULTI
		CONTROL on the Unit to set the preset number.
	5.	Press SET again.
		“STORED” appears for 2 seconds. The preset station is
4		stored in the memory.
	6.	Repeat steps 1 to 5 for each station you want to store in memory
		using different preset numbers.
	CAUTION: If the Unit is unplugged or if a power failure occurs, the preset
	stations will be erased in a few days. If this happens, preset the station
	again.

FM MODE

Changing the FM Reception Mode

When an FM stereo broadcast is hard to receive or noisy, press FM MODE on the Remote Control so that the MONO indicator lights up on the display. Reception improves, but there is no stereo effect.

To restore the stereo effect, press FM MODE on the Remote Control so that the MONO indicator goes out. In this stereo mode, the STEREO indicator lights up and you can hear stereo effects, when a program is broadcast in stereo.

13