JVC CA-DXT7, CA-DXT9 manual @ Speakers

English

@Speakers

To connect the speaker cords

•When connecting the speaker cords, match their polarity with that of the speaker terminals: blue/red/green/white/ gray to (+) and black to (–).

For CA-DXT9

From right front speaker (blue/black)

From left front speaker (blue/black)

From right subwoofer (red/black)

From left subwoofer (red/black)

From right surround	From center
	speaker
speaker (white/black)
	(green/black)

From left surround speaker (white/black)

For CA-DXT7

From right front speaker (blue/black)

From left front speaker (blue/black)

From subwoofer (red/black)

From center speaker (green/black)

From right surround	From left surround
speaker (gray/black)	speaker (gray/black)

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the System.

•The front and center speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

• DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

Speaker layout

To enjoy multi-channel sound, locate the speakers as follows. If you cannot locate like this, adjust the speaker setting by using the Setup menu (see page 40).

For CA-DXT9

For CA-DXT7

6