English
Using Recording Timer
With Recording Timer, you can make a tape of a radio broadcast automatically.
You can set the timer whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the clock while the unit is off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOLUME MIN,” and starts recording when the
The timer setting remains in memory until you change it.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
•To correct a mis entry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
4 Set the |
| E |
unit to turn on at. |
| PR SET |
|
|
1)Turn 4/ ¢ to set the hour, then press SET/DISPLAY.
2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.
“SET” appears for 1 second, then
the unit enters
SET /
DISPLAY
R E C 
5 Set the
1)Turn 4/ ¢ to set the hour, then press
SET/DISPLAY.
2)Turn 4/ ¢ to set the minute, then press
SET/DISPLAY.
“SET” appears for 1 second, then the unit enters preset station selecting mode.
1 Insert a recordable cassette with the exposed part of the tape down.
2 Press CLOCK/TIMER | / TIMER |
| CLOCK |
repeatedly until “REC” |
|
appears on the display. |
|
The 
(Timer) indicator lights up and the REC (Recording Timer) indicator also starts flashing on the display.
R E C 
•Each time you press the button, the timer setting modes change as follows:
|
|
| DAILY |
|
|
| TIMER |
|
|
|
| REC |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
| (Daily Timer setting) |
|
|
| ||||||
|
| Canceled |
|
| Clock |
|
|
|
| TIMER |
| |||
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
| setting | (Recording Timer setting) |
| |||||
|
|
| (The hour digits start flashing.) |
| ||||||||||
3 Press CLOCK/TIMER again. | / TIMER | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| CLOCK |
“TIMER” appears for 2 seconds, then the unit enters
R E C 
6 Select the preset station.
1)Turn 4/ ¢to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.
“SET” appears for 1 second.
2)Turn 4/ ¢ to select a preset channel number, then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. “OK 
” appears on the display for 2 second.
The settings you have done are shown on the display in sequence for your confirmation.
7 Press 
to turn off the unit (on standby) if necessary.
•If you want to listen to another source while recording Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.
•Even if you unplug the AC power cord or if a power failure occurs
Once you set the timer, the timer setting may remain stored in memory for a few days. In this case, check whether the timer setting still remains or not.
– 25 –
