JVC CA-HXZ1R manual Turning On or Off the Power Setting the Clock, To turn on the unit, press

English

Common Operations

Turning On or Off the Power			Setting the Clock
To turn on the unit, press		(or	You can set the clock whether the unit is on or off; however,
STANDBY/ON	on the remote control)		if Ecology Mode is activated, you cannot set the clock while
so that the lamp on the button goes off.			the unit is off. “0:00” flashes on the display until you set the
			clock.

To turn off the unit (on standby), press

(or STANDBY/ON on the remote control) again so that the lamp on the button lights up.

•A little power is always consumed even while the unit is on standby.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

CLOCK / TIMER

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.

Saving the Power Consumption while on Standby —Ecology Mode

You can save the power consumption while the unit is turned off (on standby).

• You can set Ecology Mode whether the unit is on or off.

On the unit ONLY:

To activate the Ecology Mode, press ECO.

ECO

“ECO” appears on the display for 2 seconds (and the demonstration is canceled if you have pressed the button while the unit is off).

•Each time you press the button, “ECO” and “NORMAL” appear alternately on the display.

To deactivate the Ecology Mode, press ECO again. “NORMAL” appears (and the demonstration starts if the unit is turned off).

When you turn off the unit with Ecology Mode activated

“ECO” flashes on the display, and the clock time will not be shown while the unit is turned off.

Turning On or Off the Key-touch Tone

If you do not want the key-touch tone to beep each time you press a button, you can deactivate it.

On the remote control ONLY:

Press BEEP ON/OFF.	BEEP
	ON/OFF

•Each time you press the button, the key-touch tone turns on and off alternately.

2 Turn 4/ ¢to adjust the	E
hour, then press SET/DISPLAY.	PR SET

The minute digits start flashing on the display.

If you want to correct the hour		SET /
	CANCEL / DEMO	DISPLAY
after pressing SET/DISPLAY,
press CANCEL/DEMO.
The hour digits start flashing again.

3 Turn 4/ ¢to adjust the minute, then press SET/DISPLAY.

To check the clock time

Press and hold SET/DISPLAY while playing any source.

•Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have set the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY TIMER REC

(Daily Timer setting)

Canceled	Clock		TIMER
	setting	(Recording Timer setting)

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” If this happens, set the clock again.

– 9 –