JVC CA-HXZ1R manual Connecting Speakers, To connect an outdoor AM antenna

Continued

AM antenna Connecting Speakers

1
2
ANTENNA	Vinyl-covered wire
	(not supplied)
AM EXT
AM LOOP
FM 75
COAXIAL
3
AM loop antenna
(supplied)

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

1
2		3
Speaker cords		Speaker cords
(black/blue)		(black/blue)
RIGHT	LEFT
		MAIN
		SPEAKERS
		SUBWOOFERS
CAUTION: SPEAKER IMPEDANCE 6		16
Speaker cords
(black/red)
From right	From left
subwoofer	subwoofer
From main		From main
right speaker		left speaker

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Insert the end of the speaker cord into the

terminal as illustrated.

Match the same polarity: (+) to (+) and (–) to (–).

3Close the speaker terminals.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

• DO NOT connect more than one speaker to each speaker terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

– 8 –