JVC CA-HXZ1R Turning On or Off the Key-touchTone, Adjust the SEA pattern, Press SET/DISPLAY again

Your individual mode stored in memory. See “Creating Your Own Sound Mode—User Mode” below.

The sound mode is canceled.

Boosts low and high frequency. Good for acoustic music.

Good for vocal music. Good for classical music.

Surround modes*

DANCE: Increases resonance and bass.

HALL: Adds depth and brilliance to the sound.

STADIUM: Adds clarity and spreads the sound, like in an outdoor stadium.

SEA (Sound Effect Amplifier) modes

ROCK:

POP:

CLASSIC:

User Modes

USER 1/2/3:

OFF:

*Surround elements are added to the SEA elements to create a being-there feeling in your room.

3 Adjust the SEA pattern.

1)Turn 4/ ¢ to select the frequency range (LOW1, LOW2, MID, HIGH1, and HIGH2).

2)Press 1 or Á to adjust the level (–3 to +3) of the selected frequency range.

3)Repeat steps 1) and 2) to adjust the level of the other frequency ranges.

4 Press SET/DISPLAY again.

PR	E
	SET

SET /

DISPLAY

Creating Your Own Sound Mode—User Mode

You can change SEA pattern to suit your preference. The SEA pattern can be adjusted into 5 frequency range—LOW1, LOW2, MID, HIGH1, and HIGH2. These changed settings can be stored in the USER 1, USER 2, and USER 3 modes.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the unit ONLY:

5 Turn 4/ ¢to select one of the user modes (USER 1, USER 2, and USER 3) which you want to store the SEA pattern.

6 Press SET/DISPLAY again.

PR	E
	SET

SET /

DISPLAY

1 Select one of the preset sound modes.

•If you want to add the surround elements in your SEA pattern, select one of the surround modes (DANCE, HALL, or STADIUM) before starting the procedure below. (See “Selecting the Sound Modes” on page 11.)

2	Press SET/DISPLAY while the	SET /
		DISPLAY

selected sound mode is still shown on the display.

The SEA pattern you have created are stored into the user mode selected in the above step.

To use your own sound mode

Select USER 1, USER 2, or USER 3 mode when using the sound modes. See “Selecting the Sound Modes” on page 11.

When you unplug the AC power cord or if a power failure occurs

The setting will be erased in a few days. If this happens, set the user modes again.

Turning On or Off the Key-touch Tone

If you do not want the key-touch tone to beep each time you press a button, you can deactivate it.

	On the remote control ONLY:
	Press BEEP ON/OFF.
Current level appears.	• Each time you press the button, the key-touch
	tone turns on and off alternately.

BEEP

ON/OFF

– 12 –