JVC CA-HXZ1R Common Operations, Turning On or Off the Power, Setting the Clock, Press CLOCK/TIMER

Common Operations

Continued

Turning On or Off the Power

To turn on the unit, press (or

STANDBY/ON on the remote control) so that the lamp on the button goes off.

Setting the Clock

You can set the clock whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the clock while the unit is off. “0:00” flashes on the display until you set the clock.

To turn off the unit (on standby), press

(or STANDBY/ON on the remote control) again so that the lamp on the button lights up.

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 13) will be erased in a few days.

Saving the Power Consumption while on Standby —Ecology Mode

You can save the power consumption while the unit is turned off (on standby).

• You can set Ecology Mode whether the unit is on or off.

On the unit ONLY:To activate the Ecology Mode, press ECO.

ECO

“ECO” appears on the display for 2 seconds (and demonstration is canceled temporarily if you have pressed the button while the unit is off).

•Each time you press the button, “ECO” and “NORMAL” appear alternately on the display.

To deactivate the Ecology Mode, press ECO again. “NORMAL” appears (and demonstration starts if the unit is turned off).

When you turn off the unit with Ecology Mode activated

“ECO” flashes on the display, and the clock time will not be shown while the unit is turned off.

On the unit ONLY:

1 Press CLOCK/TIMER.	/ TIMER
	CLOCK

The hour digits start flashing on the display.

2 Turn 4/ ¢to adjust the	E
hour, then press SET/DISPLAY.	PR SET

The minute digits start flashing on the display.

		SET /
If you want to correct the hour	CANCEL / DEMO	DISPLAY
after pressing SET/DISPLAY,
press CANCEL/DEMO.
The hour digits start flashing again.

3 Turn 4/ ¢to adjust the minute, then press SET/DISPLAY.

To check the clock time

Press and hold SET/DISPLAY while playing any source.

•Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have set the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY TIMER REC

(Daily Timer setting)

Canceled	Clock		TIMER
	setting	(Recording Timer setting)

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” You need to set the clock again.

– 10 –