JVC CA-HXZ9 Playing Back Discs, Loading Discs, When playing a CD-Ror CD-RW, When they light up?

Playing Back Discs Continued

English

This unit has been designed to play back the following discs:

•CD (Audio CD)

•CD-R (CD-Recordable)

•CD-RW (CD-ReWritable)

When playing a CD-R or CD-RW

User-edited CD-Rs (CD-Recordable) and CD-RWs (CD-ReWritable) can be played back only if they are already “finalized.”

•You can play back your original CD-Rs or CD-RWs recorded in music CD format. (However, they may not be played back depending on their characteristics or recording conditions.)

•Before playing back CD-Rs or CD-RWs, read their instructions or cautions carefully.

•Some CD-Rs or CD-RWs may not be played back on this unit because of their disc characteristics, damage or stain on them, or if the player’s lens is dirty.

•CD-RWs may require a longer readout time. This is caused by the fact that the reflectance of CD-RWs is lower than for regular discs.

Loading Discs

On the unit ONLY:

1 Press 0 for the disc tray (CD1, CD2, or CD3) you want to load a disc onto.

The unit automatically turns on and the disc tray comes out.

2 Place a disc correctly on the circle of the disc tray, with its label side up.

CORRECT INCORRECT

•When using a CD single (8 cm), place it on the inner circle of the disc tray.

About the CD ready lamps

Each CD ready lamp corresponds to the disc tray of the same number.

•When they light up?

–When you turn on the unit for the first time after plugging into a wall outlet, all CD ready lamps (CD1 READY, CD2 READY, and CD3 READY) light up. From the next time on, CD ready lamp(s) light(s) up according to the previous condition.

–Each time you press the disc tray open/close buttons

—0(CD1, CD2, and CD3), the corresponding CD ready lamp lights up.

•When they go off?

Only when the unit detects there is no disc loaded on a certain tray, the corresponding CD ready lamp goes off. (“NO DISC 1,” “NO DISC 2,” or “NO DISC 3” appears on the display.)

•When they flash?

The corresponding CD ready lamp flashes during playback and pause.

3 Press the same 0 you have pressed in step 1.

The disc tray closes.

4 Repeat steps 1 to 3 to place other discs.

When loading more than one disc

When you press 0 for the next tray you want to place another disc onto, the first disc tray automatically closes and then the next tray comes out.

14