JVC CA-MXDVA5 manual Turning On or Off the Power, Setting the Clock, Selecting the Sources

Common Operations	Continued
Turning On or Off the Power	3 Press 4or ¢to adjust the PRESET
To turn on the unit, press	minute, then press SET.
STANDBY/ON so that the STANDBY STANDBY	STANDBY/ON
lamp goes off.
	SET

English

To turn off the unit (on standby), press	STANDBY
STANDBY/ON again so that the	STANDBY/ON
STANDBY lamp lights up.

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –,” while the tuner preset stations (see page 13) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:

1	Press CLOCK/TIMER.	CLOCK
		/ TIMER

The hour digits start flashing on the display.

2 Press 4or ¢to adjust the	PRESET
hour, then press SET.

To check the clock time

Press DISPLAY while playing any source.	DISPLAY
• Each time you press the button, the source
indication and the clock time alternate on the
display.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

Canceled CLOCK ON TIME

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

Selecting the Sources

To listen to the FM/AM broadcasts, press FM/AM. (See

page 13.)

To play back discs, press DVD 6. (See pages 14 – 35.) To play back tapes, press TAPE 23. (See page 36.)

To select the external equipment as the source, press AUX.

When you press the play button for a particular source (AUX, FM/AM, DVD 6, and TAPE 23), the unit turns on and the unit starts playing the source if it is ready.

SET

•If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.

– 10 –