Continued

English

AM antenna

Vinyl-covered wire (not supplied)

1

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

Connecting Speakers

For CA-MXG950V/G880V/G850V/GA9V/GA8V

 

1

 

3

 

 

2

 

 

Red

 

 

Speaker cords

Speaker cords

(red/black)

 

 

(red/black)

Black

Black

 

Blue

 

 

 

Speaker cords

 

 

(blue/black)

 

MAIN

SUBWOOFER

SUBWOOFER

MAIN

Right speaker

Left speaker

1Open the speaker terminals on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colours) of the speaker terminals: Red

(+)to red (+) and black (–) to black (–); Blue (+) to blue

(+)and black (–) to black (–).

3Close the speaker terminals.

Make sure the antenna conductors do not touch any other terminals and connecting cords.

Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

• DO NOT connect more than one speaker to each speaker terminal.

DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

– 7 –

Page 11
Image 11
JVC CA-MXG850V, CA-MXGA8V manual Connecting Speakers, Turn the AM loop antenna until you have the best reception, AM antenna