Connecting Other Equipment
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power 
is on.
•DO NOT plug in any equipment until all connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are coloured: White plugs and jacks are for left audio signals, and red ones for right audio signals.
Audio equipment
To audio output
English
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.
Voltage mark
Use a screwdriver to rotate the voltage selector so the voltage number the voltage mark is pointing at is the same as the voltage where you are plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.
For playing the other equipment through this unit,
connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).
To connect audio equipment with an optical digital input terminal
You can record CD sound onto the connected digital equipment.
Now, you can plug in the AC power cord.
When connecting the AC power cord to a wall outlet, the unit automatically starts display demonstration.
•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.
To optical digital input
Protective plug
Before connecting the other equipment, remove the protective plug from the terminal.
Audio equipment with an optical digital input
Cancelling the Display Demonstration
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO until “DEMO OFF” appears on the display.
When you press other buttons
The display demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) unless you cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more than 1
Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the CD OPTICAL DIGITAL OUTPUT terminal.
second.
– 9 –
