Installing the Projector

Precautions for Installation

CAUTION

Do not install the projector in the following places :

There is much water, humidity or dust.

The projector may be subjected to oil smoke or cigarette smoke.

On a soft surface such as a carpet or cushion.

The projector may be subjected to direct sunlight.

Temperature is high or humidity is low.

Allowable operation temperature range: + 5°C to + 35°C (41°F to 95°F)

Allowable relative humidity range:

20% to 80% (no condensation)

Allowable storage temperature range:

–10°C to +60°C (14°F to 140°F)

When installing the projector, observe the followings:

• Do not use the projector placed on its side.

Avoid using the projector placed on its side. This could cause a malfunction.

• Use the projector within the installed angle.

Avoid using the projector inclined ±30°or more right-to-left or left-to-right. This could cause color variation or harm the lamp life.

• Do not block the exhaust vents.

Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature inside becomes equal to the outside temperature.

Allowable minimum space required

 

20cm (7 - 7/8”)

20cm (7 - 7/8”)

50cm (19 - 3/4”)

20cm (7 - 7/8”)

ENGLISH

20cm (7 - 7/8”)

15

Page 16
Image 16
JVC DLA-S15U Installing the Projector, Precautions for Installation, Do not install the projector in the following places