M L | JVC DLA-SH4KNL guide

Rear

G H I

DVI 1

DVI 2

R	CONTROL
	USB	Exhaust air
Q	DVI 3	Exhaust air
Q	LAN
		OPERATE I/B STANDBY/ON
		LAMP
P	DVI 4	WARNING
P	RS-232C

O N M L

G[DVI 1 to 4] Terminal

This is an input terminal for video signals. Connect it to the video output terminal of the computer.

(A Page 19, 21)

HVent Hole

Warm air exits from the hole after cooling the projector.

CAUTION:

●Do not block the vent holes with papers, cloth, or soft cushions. Doing so may cause heat to trap inside the projector and result in fire or malfunction.

IVent Hole (For Lamp)

Warm air exits from the hole after cooling the lamp.

JMain Power Supply Switch

Use this to turn ON/OFF the main power supply of the projector unit.

KAC Power Input Terminal

Connect the supplied cord to this terminal.

L[STANDBY/ON] Indicator

Lit (Red)	: When in the standby mode.
Lit (Green)	: When power is supplied.
Blinking (Red)	: When cooling down (cool down
	mode). (A Page 29)

Blinking (Green) : When the projected image is temporarily hidden. (A Page 29)

J K

M[LAMP] Indicator

This indicator lights up in yellow when the lamp time exceeds 1400 hours.

NOTE:

●For details on indicator displays during warnings, refer to “Warnings Using Indicators”. (A Page 47)

●A lamp life message appears when the lamp time has exceeded 1500 hours. (A Page 46)

N[WARNING] Indicator

This indicator lights up in red when abnormality occurs on this projector. For details, refer to “Warnings Using Indicators”. (A Page 47)

O[OPERATE I/B] Button

Pressing this button for one second or longer when in the standby mode (main power supply is ON) turns on the power of the projector unit. Pressing it for one second or longer when the power is ON switches the projector to the standby mode.

P[RS-232C] Terminal

This is the RS-232C interface-specific terminal. This projector can be controlled by connecting it to a computer using a RS-232C cable.

Q[LAN] Terminal

Enables control of this projector using a computer that is connected to the network.