5SCAN SIZE button

Reduces the screen size (under-scan) so that the whole screen is displayed.

6SCREENS CHECK button

Each time you press this button, the screen changes in the following order:

Normal screen[Monochrome screen[ Red screen[Green screen[Blue screen[ (back to the beginning)

7MARKER button

Turns the MARKER function ON/OFF.

•MARKER function includes MARKER SELECT, ZOOM, ASPECT SELECT, and SAFETY MARKER functions. ☞ “MARKER” on page 12

NOTES:

•Functions do not operate when they are set to OFF in the “MARKER” menu.

•Initial setting of each function in the “MARKER” menu is OFF. Before you use the MARKER function, you must change the “MARKER” menu settings first.

•The ZOOM function does not operate in the under-scan mode.

•When the ZOOM function is operated, the MARKER SELECT and the SAFETY MARKER function in the “MARKER” menu do not work.

8INPUT SELECT buttons/lamps Select an input to display.

A:Select the video signal input to the VIDEO A terminal.

B:Select the video signal input to the VIDEO B terminal.

C/D: Select the signal input to the input unit (option) which is attached to the rear panel.

•For details about how to select the input signal through the input unit, refer to the input unit’s manual.

•The corresponding lamp of the input currently selected lights up.

9Power lamp

Unlit: The main power is off.

Orange: The main power is on and the monitor is in stand-by mode.

Green: The monitor is on.

pStand-by button

Turns on and off the monitor when the main power is on.

NOTES:

•You cannot turn on the monitor if the main power switch on the rear panel is not turned on.

•You can set the delay time between when the stand-by button is pressed and when the monitor actually turns on.

☞“RUSH DELAY TIME” on page 15

￿About the status display

Displays information of the current input selection and the monitor settings for about 3 seconds.

To show the status display, set “STATUS DISPLAY” to “AUTO” or “MANUAL” beforehand.

☞“STATUS DISPLAY” on page 18

Pressing the INPUT SELECT button currently selected shows the status display.

NOTE:

When “STATUS DISPLAY” is set to “AUTO,” the status display also appears on the screen if you change the inputs or the signal condition changes.

1Input status2Signal format

•“NO SYNC” is displayed when no video signal is input or no synchronized signal is detected.

•If “NO SYNC” is displayed even though a video signal is input, check the setting of “SYNC SELECT.”

☞ “SYNC SELECT” on page 15

•“Out of range” is displayed when a noncompliant signal is input.

3Setting of “COLOR TEMP.”

☞ “COLOR TEMP.” on page 16

“* ” is displayed if white balance is adjusted in the “COLOR TEMP./BAL.” menu.

4Appears when “SYNC SELECT” is set to “EXT.” (External synchronization)

☞ “SYNC SELECT” on page 15

5Setting of SCAN SIZE

☞ “5 SCAN SIZE button” on the left column OVER: Over-scan

UNDER: Under-scan

6Setting of SCREENS CHECK

☞ “6 SCREENS CHECK button” on the left column COLOR: Normal screen

MONO: Monochrome screen

R ONLY: Red screen

G ONLY: Green screen

B ONLY: Blue screen

7Setting of MARKER

☞ “7 MARKER button” on the left column

5