English
Basic Operations
Tone Control (BASS/TREBLE)
You can control the tone by changing the bass (low frequen- cy) and treble (high frequency).
On the Remote Control
1 Press the BASS/TREBLE button.
Each time you press the button, the Tone Control mode changes as follows.
BASS = TREBLE = Normal display = (back to the begin- ning)
No signal condition:
Source CD: CD is stopped or no CD is inserted.
When no signal condition continues, “A.P.off 20 sec” (20 seconds left before elapsed time reaches three minutes) ap- pears on the display. The displayed time is counted down and, finally, the System is turned off (Standby mode).
•If a CD is played back, the “A.P.off” indicator stops blinking and stays lit again.
•If you press a button or turn the VOLUME control,
To disable the A.P.off function
2 While “BASS” or “TREBLE” appears on | When the source is “CD”, press the A.P.off button on the | |
the display, press the VOLUME + or - | Remote Control until “A.P.off STOP” appears on the dis- | |
button to adjust the bass or treble level. | play. | |
Then, the “A.P.off” indicator goes out. | ||
You can change the level within the range of | ||
| ||
|
|
3 Press the BASS/TREBLE button until normal display appears.
Waiting for five seconds will also return the System to the normal display.
Auto Power Off (A.P.off)
You can automatically turn off the System when no signal condition continues for three minutes. This function is ef- fective when the source is set to “CD”, but not to “FM”, “AM” or “LINE”.
Entering the Number with the Remote Control (Numeric Keys)
You will use the Numeric Keys on the Remote Control to enter numbers for presetting stations, recalling the preset stations, selecting track number, or programming the play- ing tracks on a CD.
How to enter the number with the Numeric Keys is ex- plained here.
Examples:
•To enter number 5, press 5.
•To enter number 10, press 10.
•To enter number 15, press +10 then 5.
•To enter number 20, press +10 then 10.
•To enter number 25, press +10, +10, then 5.
To Enable the A.P.off function (When the source is “CD”)
1 Press the A.P.off button on the Remote Control until “A.P.off SET” appears on the display.
Then, the “A.P.off” indicator lights up on the display.
•Each time you press the button, the display alternates as follows.
A.P.off SET Ô A.P.off STOP
When no signal condition is detected, the “A.P.off” indica- tor will start blinking soon.
10
