JVC GR-DF430 Operation Mode, Using AC Power, About Batteries, Power-Linked Operation

	GETTING STARTED EN 15
Using AC Power	M (Manual Recording):
Perform steps 4 – 5 in “Charging The Battery	Allows you to set various recording functions
	using the Menus. ( pg. 37)
Pack”.
	If you want more creative capabilities than Full
NOTE:
	Auto Recording, try this mode.
The provided AC Adapter features automatic	OFF:
voltage selection in the AC range from 110 V to
	Allows you to switch off the camcorder.
240 V.
	PLAY:
About Batteries
	● Allows you to play back a recording on the
DANGER! Do not attempt to take the batteries	tape.
apart, or expose them to flame or excessive	● Allows you to display a still image stored in
heat, as it may cause a fire or explosion.	the memory card or to transfer a still image
WARNING! Do not allow the battery or its	stored in the memory card to a PC.
terminals to come in contact with metals, as this	(GR-DF570/470 only)
can result in a short circuit and possibly start a	● Allows you to set various playback functions
fire.	using the Menus. ( pg. 37)
To resume the original function of the
accurate battery power indication	VIDEO/MEMORY Switch Position
If the battery power indication differs from the	(GR-DF570/470 only)
actual operating time, fully charge the battery, and	VIDEO:
then run it down. However this function may not
	Allows you to record on a tape or play back a
turn back if the battery was used for a long period
	tape. If “REC SELECT” is set to “	/	”
of time under extremely high/low temperature
	( pg. 41), still images are recorded both on
condition or charged too many times.
	the tape and the memory card.
Operation Mode	MEMORY:
To turn on the camcorder, set the Power Switch	● Allows you to record in a memory card or
	access data stored in a memory card.
to any operation mode except “OFF” while	● When the Power Switch is set to “A” or “M”,
pressing down the Lock Button located on the	the currently selected image size appears.
switch.	Power-Linked Operation
Power Switch
Lock Button	When the Power Switch is set to “A” or “M”, you
	can also turn on/off the camcorder by opening/
	closing the LCD monitor or pulling out/pushing in
	the viewfinder.
	INFORMATION:
	The following explanations in this manual
POWER/	supposes the use of LCD monitor in your
	operation. If you want to use the viewfinder,
CHARGE lamp
VIDEO/MEMORY*	close the LCD monitor and pull out the
Choose the appropriate operation mode	viewfinder fully.
according to your preference using the Power
Switch and VIDEO/MEMORY Switch.*
* GR-DF570/470 only
Power Switch Position
A (Full Auto Recording):
Allows you to record using NO special effects
or manual adjustments. Suitable for standard
recording.
The “A” indicator appears on the display.

GETTING STARTED