56 EN EDITING
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and out points. The original audio remains unchanged.
●Use the provided remote control.
NOTES:
●Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 37, 42)
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
1 Play back the tape, locate the
2 Press REW (3) until the
3 Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters
4 Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in step 1.
●To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (8).
NOTES:
●Program AE with special effects ( pg. 48) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. ( pg. 60)
