EN 57

If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

If you change from 12-bit to 16-bit in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops.

To perform Audio Dubbing while watching on the television, make connections. ( pg. 22)

To perform Audio Dubbing with a video unit connected to the camcorder’s AV connector, first set “S/AV INPUT” to “ON” in VIDEO Menu.

( pg. 31, 39)

The “AUX” indication appears instead of “MIC”.

5To end Insert Editing, press START/STOP, then STOP (8).

NOTES:

Program AE with special effects ( pg. 33) can be used to spice up the scenes being edited during Insert Editing.

During Insert Editing, the date and time information changes.

If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops. ( pg. 80)

If a memory card is loaded and “NAVIGATION” is set to other than “MANUAL”, a NAVIGATION thumbnail image is stored in the memory card. ( pg. 46)

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

START/STOP

INSERT

REW PLAY

ADVANCED FEATURES

STOP

NOTES:

PAUSE

Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 31, 40)

Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

To perform Insert Editing while watching in the television, make connections. ( pg. 22)

1Play back the tape, locate the Edit-Out point and press PAUSE (9). Confirm the time code at this point. ( pg. 40)

2Press REW (3) until the Edit-In point is located, then press PAUSE (9).

3Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4Press START/STOP to begin editing.

Confirm the insert at the time code you checked in step 1.

To pause editing, press START/STOP. Press it again to resume editing.

Page 57
Image 57
JVC GR-DV900, GR-DV700 instruction manual Insert Editing,  pg AUX indication appears instead of MIC