JVC GR-DVL108, GR-DVL109, GR-DVL309 14 EN, RECORDING Basic Recording For Video, To Stop Recording

14 EN RECORDING Basic Recording For Video

	Power Switch
Power lamp	Lock Button

	F
	F
	O
	Y
Recording	A
	L
	P
Start/Stop Button

	During
	shooting
Display
2 5	Tape remaining
	time indicator
	(Approximate)

min 90 min 89 min 3 min

(Now calculating)

0min 1 min 2 min

(Blinking) (Blinking) (Blinking)

Tally lamp

(lights while recording is in progress)

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

●Power (  pg. 6)

●Grip Adjustment (  pg. 8)

●Viewfinder Adjustment ( pg. 8)

●Load A Cassette ( pg. 10)

●Recording Mode Setting (  pg. 12)

1 Press in the tabs on the lens cap to remove it. Press PUSH OPEN, open the LCD monitor and set the VIDEO/DSC Switch to “VIDEO”.

2 Set the Power Switch to “ ” or “ ” while pressing down the Lock Button located on the switch.

Shooting while using the LCD monitor: Make sure the LCD monitor is fully open. Tilt it upward/ downward for best viewability.

Shooting while using the viewfinder: Close the LCD

monitor.

•The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed.

Press the Recording Start/Stop Button. “	” appears
3 while recording is in progress.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

To Adjust The Brightness Of The Display

.... rotate MENU/BRIGHT until the bright level indicator

on the display moves and the appropriate brightness is reached.

•If you are using the GR-DVL309 or GR-DVL308, it is also possible to adjust the brightness of the viewfinder by closing the LCD monitor and adjusting as described above.

MENU/

BRIGHT Wheel

BR I GHT – +

180° 90°

PUSH OPEN Button VIDEO/DSC Switch