Separate the Velcro strip.

10 EN

GETTING STARTED (cont.)

Power Zoom Lever

Recording Start/Stop button

Power Switch

Grip Adjustment

1

2 Pass your right hand through the loop and grasp the grip.

3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.

Diopter Adjustment Control

Viewfinder Adjustment

1 Set the Power Switch to “ ” or “ ” while pressing down the Lock Button located on the switch.

2 Turn the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.

PAUSE

 

 

Shoulder Strap Attachment

 

 

1 Make sure the battery pack is removed. Following

 

 

the illustration, thread the strap through the eyelet 1,

2

1

then fold it back and thread it through the buckle 2.

Repeat the procedure to attach the other end of the

 

 

strap to the other eyelet 3 located under the Grip

 

 

Strap . Confirm the strap is not twisted.

3

Tripod MountingCAUTION

When attaching the camcorder to a tripod, extend its legs to stabilize the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.

1 To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.