DETAILS

EN 47

 

 

I T E M S

N O T E S

 

 

➪ Power

❍ Perform charging where the temperature is between 10°C and 35°C (50°F

and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for

( pg. 8)

charging. If the environment is too cold, charging may be incomplete.

❍Charging times are for a fully discharged battery pack.

❍Charging time varies according to the ambient temperature and the status of the battery pack.

❍To avoid interference with reception, do not use the AC Adapter near a radio.

❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

❍The following operation stops charging:

• Set the Power Switch to “PLAY”,

” or

”.

•Disconnect the AC adapter from the camcorder.

•Unplug the AC adapter from the AC outlet.

•Detach the battery from the camcorder.

➪ RECORDING

❍ When you use the LCD monitor outdoors in direct sunlight, the LCD monitor

( pg. 15, 16)

may be difficult to see. If this happens, use the viewfinder instead.

❍ The cassette holder cannot be opened unless a power supply is attached.

 

 

❍ There may be a delay after you open the cassette holder cover until the

 

cassette holder opens. Do not use force.

 

❍ Once the cassette holder is closed, it recedes automatically. Wait until it

 

recedes completely before closing the cassette holder cover.

 

❍ When the Recording Start/Stop button is pressed, it may take a few seconds

 

before actual recording starts. “ ” starts rotating when the camcorder

 

actually starts recording.

 

❍ The time required to calculate and display the remaining tape length, and the

 

accuracy of the calculation, may vary according to the type of tape used.

 

❍ “TAPE END” appears when the tape reaches its end, and the power goes off

 

automatically if left in this condition for 5 minutes. “TAPE END” also appears

 

when a cassette at its end is loaded.