RECORDING | EN 15 |
Power lamp
Power Switch
| Lock Button | During |
| shooting | |
|
| |
Recording Start/Stop Button | ||
| Display |
|
|
| 25min Tape remaining time |
|
| |
|
| indicator (Approximate) |
|
|
|
min 
90 min 
89 min 
3 min
(Now calculating)
0 min
1 min
2 min
(Blinking) (Blinking) (Blinking)
BR I GHT
MENU/BRIGHT Wheel
PUSH OPEN Button
Basic Recording
NOTE:
You should already have performed the procedures listed below. If not, do so before continuing.
●Power ( pg. 8)
●Grip Adjustment ( pg. 10)
●Viewfinder Adjustment ( pg. 10)
●Load A Cassette ( pg. 12)
●Recording Mode Setting ( pg. 13)
1
2 Set the Power Switch to “ ” or “ ” while pressing down the Lock Button located on the switch. Shooting while using the LCD monitor: Make sure the LCD monitor is fully open. Tilt it upward/ downward for best viewability.
Shooting while using the viewfinder: Close the LCD monitor.•The power lamp lights and the camcorder enters the
3 Press the Recording Start/Stop Button. “ 
” appears while recording is in progress.
NOTES:
●If the
the camcorder on again, set the Power Switch to
“OFF”, then back to “ ” or 
”.
●The image will not appear simultaneously on the LCD monitor and the viewfinder. It will appear in the viewfinder when the LCD monitor is in the lock position, and it will appear on the LCD monitor when fully extended.
●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may
occur when editing the tape. To avoid this, refer to “Recording from the middle of a tape” ( pg. 18).
●To turn the beep sounds off, pg. 32, 34.
For other notes, pg. 47