48 EN

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

SYMPTOMPOSSIBLE CAUSESCORRECTIVE ACTION

1 No power is supplied.

• The power is not connected

• Connect the AC Adapter securely

 

properly.

( pg. 9).

 

• The battery is dead.

• Replace the dead battery with a

 

 

fully charged one ( pg. 8, 9).

 

 

 

2 “SET DATE/TIME!”

• The date/time is not set.

• Set the date/time ( pg. 11).

appears.

• The built-in clock battery has run

• Consult your nearest JVC dealer

 

out and the previously set date/time

for replacement.

 

has been erased.

 

 

 

 

3 Recording cannot be

• The tape’s erase protection tab is

• Set the tape’s erase protection tab

performed.

set to “SAVE”.

to “REC” ( pg. 12).

 

• The Power Switch is set to “PLAY”

• Set the Power Switch to “ ” or

 

or “OFF”.

“ ” ( pg. 16).

 

• “TAPE END” appears.

• Replace with new cassette

 

• The cassette holder cover is open.

( pg. 12).

 

 

• Close the cassette holder cover.

 

 

 

4 There is no picture.

• The camcorder is not getting

• Turn the camcorder’s power off

 

power, or some other malfunction

and on again ( pg. 16).

 

exists.

 

 

 

 

5 The focus does not adjust

• Focus is set to the Manual mode.

• Set Focus to the Auto mode

automatically.

• The recording was done in a dark

( pg. 29).

 

place, or the contrast was low.

• Clean the lens and check the focus

 

• The lens is dirty or covered with

again ( pg. 53).

 

condensation.

 

 

 

 

6 The cassette will not load

• The cassette is in the wrong

• Set it in the right position

properly.

position.

( pg. 12).

 

• The battery’s charge is low.

• Install a fully charged battery

 

 

( pg. 8, 9).

 

 

 

7 Snapshot mode cannot be

• The Squeeze mode is selected.

• Disengage the Squeeze mode

used.

 

( pg. 34).