44 EN

USING THE OPTIONAL REMOTE CONTROL UNIT (cont.)

Lock Button

Power Switch

Display

6w

12 : 3 4

Remote sensor

START/STOP

REW

PAUSESTOP

PLAYINSERT

RM-V700U (optional)

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

NOTES:

●Before performing the following steps, make sure that

“TIME CODE” is set to “ON” in the Menu Screen ( pg. 35, 37).

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections ( pg. 20).

1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point ( pg. 35, 37).

2 Press REW (2) until the Edit-In point is located, then press PAUSE (6).

3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 Press START/STOP to begin editing.•Confirm the insert at the time code you checked in step 1.•To pause editing, press START/STOP. Press it again to resume editing.5 To end Insert Editing, press START/STOP, then STOP (5).

NOTES:

●Program AE with special effects ( pg. 24, 25) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert Edting stops ( pg. 62).