26 EN RECORDING Advanced Features For Video And D.S.C. (cont.)
Fade/Wipe Effects
These effects let you make
IMPORTANT:
Some Fade/Wipe Effects cannot be used with certain modes of Programme AE with special effects ( pg. 28). If an unusable Fade/Wipe Effect is selected, its indicator blinks or goes out.
MENU/BRIGHT Wheel
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
Recording |
|
| ||||
Power Switch | ||||||
Start/Stop Button | ||||||
|
| |||||
FADE/WIPE SELECTION ( | , | , | , | , | ||||
, | , | , | , | , | and | ) |
|
|
Fade or Wipe works when video recording is started or when you stop recording.
1 Set the VIDEO/DSC Switch to “VIDEO”, then set the Power Switch to “ 
” while pressing down the Lock Button located on the switch.
2 Press MENU/BRIGHT. The Menu Screen appears.
3 Rotate MENU/BRIGHT to select “ 
”, then press it.
4 Rotate MENU/BRIGHT to select the desired function, then press it. Selection is complete.
•The FADER/WIPE Menu disappears and the effect is reserved. The indicator representing the selected effect appears.
5 Press the Recording Start/Stop Button to activate the
PICTURE WIPE OR DISSOLVE SELECTION | |||||||
( | , | , | , | , | , | and | ) |
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
To Deactivate The Selected Effect . . .
.... select “OFF” in step 4.
NOTES:
●You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/ Stop Button.
●If the power is turned off after a scene is finished recording, the stored point is erased, disabling the Picture Wipe/Dissolve combina- tion. When this happens, the Picture Wipe/ Dissolve indicator blinks. Also note that power shuts off automatically if 5 minutes elapse in the
●The sound at the end of the last recorded scene is not stored.
The Picture Wipe or Dissolve works when video recording is started.
1 Follow steps 1 through 4 above.
2 If you select Picture Wipe/Dissolve during recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene ended is stored in memory.
If you select Picture Wipe/Dissolve during Record- Standby mode . . .
.... press the Recording Start/Stop Button to start
recording and press it again when one scene is finished. The point at which the scene ended is stored in memory.
If you select Picture Wipe/Dissolve during Record- Standby mode after performing a Picture Wipe/ Dissolve . . .
.... the point at which the scene ended is already
stored in memory.
3 If you start recording a new scene within 5 minutes of the end of the previous recording (without having turned the camcorder’s power off), the previous scene wipes out, revealing the new scene.
