JVC GR-DVL707, LYT0596-001A 58 EN, Audio Dubbing, To hear the dubbed sound during playback

58 EN

Display

USING THE REMOTE CONTROL UNIT (cont.)

Audio Dubbing

6e Audio Dub

Standby mode

Speaker

Power Switch

The audio track can be customized only when recorded in the 12-bit mode (
pg. 23).

NOTES:

●Audio Dubbing is not possible on a tape recorded in

16-bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching on the television, make connections (
pg. 40).

1 Play back the tape to locate the point where editing will start, then press PAUSE (6).

2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.

3 Press PLAY (4), then begin “narrating”. Speak into the microphone.

•To pause dubbing, press PAUSE (6).

4 To end Audio Dubbing, press PAUSE (6), then STOP (5).

Remote sensor

Stereo microphone

A.DUB
T	W
AUDIO
MONITOR
PLAY
STOP
PAUSE

To hear the dubbed sound during playback . . .

.... set “12BIT MODE” to “SOUND 2” or “MIX” in the

Menu Screen (
pg. 32, 33).

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at 12-bit, the old and new soundtracks are recorded separately.

●For GR-DVL800 Owners: To select the desired sound for playback, press AUDIO MONITOR on the remote control.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit

audio or a blank portion, Audio Dubbing stops (
pg. 72).

RM-V716U	RM-V711U
(provided with	(provided with
GR-DVL707)	GR-DVL800)