JVC GR-DVL9000 Installing The Battery Pack, Notes, EN11, Charging Environment, Open Battery Cover

EN11

Charging Environment

Perform charging where the temperature is between 10° and 30°C (50°F and 86°F). 20° to 25°C (68°F to 77°F) is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.

Continuous Shooting

Continuous shooting is possible (See table below for recording time) under the following conditions:

•A BN-V814U Battery Pack is in use

•The temperature is approximately 20°C/68°F

However, . . .

•If the temperature is below 10°C/50°F, or

•If zoom or Record-Standby are engaged or LCD monitor is used repeatedly, continuous shooting capability is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.

Approximate recording time (unit: min)

No. of batteries to supply power	LCD monitor off/	LCD monitor on/
	Viewfinder on	Viewfinder off
Using one battery installed in the camcorder	100	80
Using two batteries; one in the camcorder and
one in the Power Pack (optional) attached to the	180	140
camcorder

Installing The Battery Pack

The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has been charged fully.

Battery cover

Battery

Hook

Open switch (BATTERY)

1

2

OPEN BATTERY COVER

Slide the open switch.

INSERT CHARGED BATTERY

Insert the mark end of the battery first until you hear a click. The hook rises. Inserting the battery backwards will result in malfunction.

NOTES:

●To remove the battery, turn off the camcorder, open the battery cover and push down the hook.

●Be careful not to drop the battery pack.

●The hook is tight to prevent the battery from dropping.

3 CLOSE BATTERY COVER