JVC GR-DVM828 manual Remote Control Unit, Installing The Battery, Pull OUT Battery Holder

16ENGETTINGSTARTED(Cont.)

Remote Control Unit

You can use the RM-V712U to control the camcorder. When using the remote control, be sure to point it at the remote sensor. The transmitted beam effective area for indoor use is approx. 5 m. The transmitted beam may not be effective or may cause incorrect operation if the remote sensor is directly exposed to sunlight or powerful lighting.

START/STOP Button (☞ pg. 19)

PAUSE IN connector (☞ pg. 63)

Zoom Buttons (☞ pg. 50)

DISPLAY Button
(☞ pg. 60)	T W

SHIFT Button (☞ pg. 50)

SLOW Rewind/Forward

Buttons (☞ pg. 49)

Left/Right Buttons (☞ pg. 50)

FADE/WIPE Button (☞ pg. 63)

EFFECT Button (☞ pg. 51)

EFFECT ON/OFF Button (☞ pg. 51)

AUDIO MONITOR Button (☞ pg. 53)

MBR SET Button (☞ pg. 62)

Down Button (☞ pg. 50)

A.DUB Button (☞ pg. 68)

Up Button (☞ pg. 50)

Operation Buttons (☞ pg. 50, 60)

R.A. EDIT Buttons (☞ pg. 63 – 65)

Installing The Battery

The RM-V712U uses one lithium battery (CR2025).

	PULL OUT BATTERY HOLDER
	1 Pull out in the direction of the arrow while
	pressing the knob as shown.
	INSERT BATTERY IN HOLDER
	2 Insert the battery in the holder, and be sure to
	have the “+” mark visible.
	RE-INSERT HOLDER
	3 Slide the holder back in until you hear a click.
Knob	•Read the warning concerning lithium
	batteries (☞ pg. 2).