JVC GR-DVM828 manual These spots are not recorded

74EN

TROUBLESHOOTING(Cont.)

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

36.Coloured bright spots appear all over the LCD monitor or the viewfinder.

36. •The LCD monitor or the	36.
viewfinder is made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD	————
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due
to any defect of the unit.
(Effective dots: more than
99.99 %)

37. The LCD monitor	37. •During playback of the	37.
indications are distorted.	unrecorded portion, High-
	speed Search and still	————
	playback, LCD monitor
	indications appear distorted.
	This is not a defect.
38. An unusual mark appears	38.	38. • Check the section of the
in the LCD monitor or the		manual that explains LCD
viewfinder.	————	monitor/viewfinder
		indications
		(☞ pgs. 79 – 81).
39. An error indication	39. •A malfunction of some kind	39. • Remove the power supply
(E01 — E06) appears in	has occurred. In this case	(battery pack, etc.) and
the LCD monitor or the	the camcorder’s functions	press RESET button, and
viewfinder.	become unusable.	wait a few minutes for the
		indication to clear. When it
		does, you can resume using
		the camcorder.
		If the indication remains
		even though you repeat the
		above two or three times,
		please consult your nearest
		JVC dealer.
40. The charge indicator on	40. •The temperature of the	40. • To protect the battery, it is
the AC Charger Station	battery is extremely high/low.	recommended to charge it
does not light.	•Charging is difficult in places	in places with a temperature
	subject to extremely high/	of 10°C to 30°C (☞ pg. 9).
	low temperatures.
41. The recording mode	41. •This occurs when recording	41.
indicator “LP” blinks on	in the LP mode is not
the LCD monitor or the	available. After the indicator	————
viewfinder.	blinks, the recording mode
	switches to “SP” and
	recording goes on.
42. Picture does not appear	42. •The viewfinder is pulled out.	42. • Push the viewfinder back in.
on the LCD monitor.	•The LCD monitor’s bright-	• Adjust the brightness of the
	ness setting is too dark.	LCD monitor (☞ pg. 22).

• If the monitor is tilted upward 180 degrees, open the monitor fully

(☞ pg. 23).

43.When the image is printed 43. •This is not a malfunction. from the printer, a black

bar appears at the bottom of the screen.

43.• By recording with Digital Image Stabilizer set to “ON” (☞ pg. 32) this can be avoided.