![](/images/new-backgrounds/1131416/13141615x1.webp)
8 EN
Automatic Demonstration
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “A” or “M” and no cassette is in the camcorder.
Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minute after that, the demonstration will resume.
“DEMO MODE” remains “ON” even if the camcorder power is turned off.
To cancel Automatic Demonstration:
1)Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2)Open the LCD monitor fully, or pull out the viewfinder fully.
3)Press the MENU Wheel in. The Menu Screen appears.
4)Rotate the MENU Wheel to select “s SYSTEM”, and press it. The SYSTEM Menu appears.
5)Rotate the MENU Wheel to select “DEMO MODE”, and press it. The Sub Menu appears.
6)Rotate the MENU Wheel to select “OFF”, and press it.
7)Rotate the MENU Wheel to select “BRETURN”, and press it twice. The normal screen appears.
NOTE:
Detach the lens cap to see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
MENU Wheel
509 only
Power Switch
AY OFF A | M |
PL |
Lock Button
Sub Menu
DEMO MODE | OFF |
| ON |