![](/images/new-backgrounds/1131416/131416161x1.webp)
DETAILS | EN 81 |
|
|
ITEMS | NOTES |
V Power ( pg. 10) | ● Perform charging where the temperature is between 10°C and 35°C. 20°C to |
| 25°C is the ideal temperature range for charging. If the environment is too cold, |
| charging may be incomplete. |
| ● Charging times noted above are for a fully discharged battery pack. |
| ● Charging time varies according to the ambient temperature and the status of the |
| battery pack. |
| ● To avoid interference with reception, do not use the AC Adapter near a radio. |
| ● Since the AC Adapter processes electricity internally, it becomes warm during |
| use. Be sure to use it only in |
| ● The following operation stops charging: |
| •Set the Power Switch to “P”, “A” or “M”. |
| •Disconnect the AC Adapter from the camcorder. |
| •Unplug the AC Adapter from the AC outlet. |
| •Detach the battery from the camcorder. |
|
|
V VIDEO | ● When you use the LCD monitor outdoors in direct sunlight, the LCD monitor |
RECORDING | may be difficult to see. If this happens, use the viewfinder instead. |
( pg. 19, 20) | ● The cassette holder cannot be opened unless a power supply is attached. |
| ● There may be a delay after you open the cassette holder cover until the cassette |
| holder opens. Do not use force. |
| ● Once the cassette holder is closed, it recedes automatically. Wait until it recedes |
| completely before closing the cassette holder cover. |
| ● When the Recording Start/Stop button is pressed, it may take a few seconds |
| before actual recording starts. The “T” indicator starts rotating when the |
| camcorder actually starts recording. |
| ● The time required to calculate and display the remaining tape length, and the |
| accuracy of the calculation, may vary according to the type of tape used. |
| ● “TAPE END” appears when the tape reaches its end, and the power goes off |
| automatically if left in this condition for 5 minutes. “TAPE END” also appears |
| when a cassette at its end is loaded. |
| ● During recording, sound is not heard from the speaker. To hear the sound, |
| connect optional headphones to the headphone connector. |
| The sound volume is at the level it was adjusted to during playback. ( pg. 22) |
|
|