JVC GR-SXM86ED specifications 42 EN, Select Scenes

42EN

USINGTHEREMOTECONTROLUNIT

(cont.)

Remote sensor

		OF	A
	Y	F		M
L	A
P

Power Switch	PLAY
REW	FF
EDIT IN/OUT	R.A.EDIT
CANCEL	ON/OFF

SELECT SCENES

4 Point the remote control at the camcorder’s remote sensor. Press PLAY (4), then press R.A.EDIT ON/OFF on the remote control. The R.A. Edit counter display appears.

5 Press REW (2) or FF (3) to locate the beginning of

the scene you want, then press EDIT IN/OUT to register that point. The data appears under “IN” on the display.

6 Press REW (2) or FF (3) to locate the end of the scene and press EDIT IN/OUT to register it.

•The data appears under “OUT” on the display. •The total time of the registered scene(s) is displayed

at the bottom of the screen.

7 Repeat steps 5 and 6 for each additional scene (as many as 8).

8 To make corrections, press CANCEL during steps 5 and 6 to erase the most recently registered point.

	I N	OUT
1	0 : 0 0 : 2 5	– – : – – : – –
2
3
4
5
6
7
8		0 : 0 0 : 2 5
COUNT ER
TOTAL		0 : 0 0 : 0 0
	I N	OUT
1	0 : 0 0 : 2 5	0 : 0 1 : 0 5
2	0 : 0 3 : 1 8	0 : 0 3 : 3 1
3	0 : 0 2 : 3 3	0 : 0 2 : 5 3
4	0 : 0 4 : 1 1	– – : – – : – –
5
6
7
8		0 : 0 4 : 1 1
COUNT ER
TOTAL		0 : 0 1 : 1 3

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, there should be at least

15 seconds between an out-point and the next in-point.

●Blank portions of a tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing does not take place.

●Pressing R.A.EDIT ON/OFF clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.

●Turning off the camcorder’s power erases all registered in- and out-points.