12
CONNECTION
A pin plug is attached to the tip or the speaker cord. If the speaker
connection terminal on the amplifier to which the speaker is to
be connected is a pin jack, connect the left-hand speaker’s lead
to the left terminal, and the right-hand speaker’s lead to the right
terminal.
•Turn off power of all equipment before connecting the speakers
to the amplifier.
•The nominal impedance of the SP-DSC99TN is 16 Ω. Connect
them to your amplifier with the load impedance of 16 Ω .
•The nominal impedance of the SP-DSS99TN is 16 Ω. Connect
them to an amplifier with the load impedance of 16 Ω speaker.
•The maximum power handling capacity is shown in the
SPECIFICATIONS. Excessive input to the speaker will result
in abnormal noise and possible damage. The following cases
described below may cause an overload of the speakers. Be
sure to lower the amplifier volume beforehand.
1) Noise during FM tuning.
2) High level signals containing high frequency components
produced by a tape deck in the fast forward mode.
3) Click noise produced when turning power of other compo-
nents on and off.
4) Click noise produced when connecting or disconnecting
cords with the power on.
5) Click noise when the cartridge is replaced with the power
on .
6) Click noise produced when operating amplifier switches.
7) Continuous high frequency oscillation or high pitch musi-
cal instrument sound.
8) Howling or feed back when using a microphones.
SPECIFICATIONS
SP-DSC99TN
Type : Full range bass-reflex type
(Magnetically-shielded type)
Speaker
Full range : 8 cm (3-3/16 in.) cone × 1
Power Handling Capacity : 30 W
Impedance : 16 Ω
Frequency Range : 70 Hz—25 000 Hz
Sound Pressure Level : 84 dB/W·m
Dimensions (W × H × D) : 245 mm × 110 mm × 145 mm
(9-11/16 in. × 4-3/8 in. × 5-3/4 in.)
Mass : 0.8 kg (1.8 lbs)
SP-DSS99TN
Type : Full range bass-reflex type
Speaker
Full range : 8 cm (3-3/16 in.) cone × 1
Power Handling Capacity : 30 W
Impedance : 16 Ω
Frequency Range : 85 Hz—20 000 Hz
Sound Pressure Level : 83 dB/W·m
Dimensions (W × H × D) : 160 mm × 110 mm × 136 mm
(6-5/16 in. × 4-3/8 in. × 5-3/8 in.)
Mass : 0.55 kg (1.3 lbs)
Design and specifications subject to change without notice.
Amplifier connection
Verstärkeranschluß
Raccordement à l'amplificateur
Aansulaiten op de versterker
Anslutning till en förstärkare
Conexión al amplificador
Collegamento dell'amplificatore
Forstærkertilslutning
Vahvistimen liitäntä
Wall mounting hole
Loch für Wandmontage
Trou de montage à mur
Gaatje voor wandmontering
Orificio para montaje en la pared
Foro di montaggio al muro
Hål för väggmontering
Monteringshul i væggen
Aukko seinään asennusta varten
Amplifier output terminals
Ausgang des Verstärkers
Bornes de sortie de l'amplificaterur
Uitgangsaansluitengen van de versterker
Terminales de salida de amplificador
Terminali de uscita dell'amplifcator
Utgångar på förstärkaren
Forstærkerudgangsbøsninger
Vahvistimen ulostuloliittimet
Amplifier output terminals
Ausgang des Verstärkers
Bornes de sortie de l'amplificaterur
Uitgangsaansluitengen van de versterker
Terminales de salida de amplificador
Terminali de uscita dell'amplifcator
Utgångar på förstärkaren
Forstærkerudgangsbøsninger
Vahvistimen ulostuloliittimet
Diffusori surround
Surroundhögtalare
Surroundhøttaler
Ympäristötilkakaiuttimet
Surround speakers
Rundumlautsprecher
Enceintes surround
Surroundluidsprekers
Altavoces perimétricos
Diffusore centrale
Mitthögtalare
Centerhøjttaler
Keskikaiutin
Center speaker
Mittenlautsprecher
Enceinte centrale
Middenluidspreker
Altavoz central
▼
SP-MXDVA9R.E65 5/23/2001, 13:0012