TV/monitor
Connect the COMPONENT,
Red
Blue
•If an external device is not equipped with a stereo mini plug audio output, use a plug adaptor to convert the stereo mini plug to the corresponding plug of the audio output.
When connecting a USB mass storage class device
USB cable | At the front |
(not supplied) | panel |
Green | Component video cord |
(not supplied)
•To select progressive scanning mode (see page 14), use COMPONENT jacks.
Composite video cord (supplied)
•You can connect a USB mass storage class device such as a USB flash memory device, hard disk drive, multimedia card reader, etc. to this System. See pages 10 and 37 for details.
•If you press USB MEMORY 3, the System detects the USB mass storage class device and the control screen appears on the TV screen. See page 26 for details.
•You cannot connect a computer to the USB MEMORY terminal of the System.
Before plugging in the System (except for Australia)
Set the correct voltage for your area with the voltage selector on the rear.
•After connecting a TV, select the proper video signal mode according to the connection method. See “Changing the Scanning Mode” on page 14.
@Digital audio component
VOLTAGE
SELECTOR
110V
127V
220V 230V
Use a screwdriver to set the voltage selector to the same voltage as where you are plugging in the unit. (See also the back cover page.)
Protective cap | Preparing the remote control |
|
•Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu correctly according to the connected digital audio equipment (see page 36). If the setting is incorrect, loud noise may be generated causing damage to the speakers.
When connecting a portable audio device (AUX)
Stereo mini plug | At the front |
(not supplied) | panel |
•By using QP Link (Quick Portable Link), you can easily start playing back a portable audio device on this unit. See page 11 for details.
•Dispose of batteries in the proper manner, according to federal, state, and local regulations.
DO NOT recharge, short, disassemble, heat the battery or dispose of it in a fire.
When using the remote control
Point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.
5
