12. SETUP MENUVCR SETUP MENU CONTENTS
Item
Factory
Setting

Group

Contents
(Upper row: Viewfinder display
Lower row: Counter display indication
SERVO
/SYSTEM
AUDIO
050: REMOTE SELECT
rnSL
082: BACK TALLY MODE
rtMd
244:
LOW CUT
LctF
245: SAMPLING RATE
snPL
246: FRONT VOLUME
ENABLE
FruL
LOCAL
IEEE1394
RS232C
Lc
IE
23
OFF
ON
BLINK
oF
on
bL
OFF
CH1
CH2
CH1 &
CH2
oF
01
02
on
32K
48K
32
48
DISABLE
ENABLE
oF
on
Selection of the method for remote control of the VCR.
LOCAL : Choose this setting when the VCR should
be controlled using the operation buttons
on the GY-DV500 only.
IEEE1394: Choose this setting when the VCR should
be remote controlled from a DV connector
equipped video component connected to
the DV connector on the rear section of the
GY-DV500.
RS232C : Choose this setting for control by means of
the VCR remote control signal from the VTR
REMOTE connector on the GY-DV500.
* The operation buttons on the GY-DV500 remain
effective even when set to IEEE1394 or RS232C.
Selection of the lighting pattern of the BACKTALLY lamp
on the rear section during recording.
OFF : The lamp is always off.
ON : The lamp lights during recording. It remains
off until the VTR trigger button is pressed
to start the recording.
BLINK : The lamp lights during recording. It blinks
when the VTR trigger button is pressed to
start the recording.
To select whether or not the low frequencies of the audio
signal from the audio input connectors are cut. Set to
ON to reduce the wind noise of the microphone.
OFF : The CH1 and CH2 low frequencies are not
cut.
CH1 : Only the low frequencies of the audio signal
input to the CH1 channel are cut.
CH2 : Only the low frequencies of the audio signal
input to the CH2 channel are cut.
CH1 & CH2 :The low frequencies are cut for both CH1
and CH2.
To select the sampling rate for digital PCM audio
recording.
32K : Digital recording occurs with 12-bit, 32 kHz
sampling
48K : Digital recording occurs with 16-bit 48 kHz
sampling.
* The DV format offers recording tracks for up to 4
channel when recording using 12-bit, 32 kHz
sampling The GY-DV500 records two of these tracks.
The GY-DV500 does not allow after-recording.
To select whether or not the front section recording level
control should be operative. The front section recording
level control only affects the audio signal recorded on
CH1.
DISABLE : Use of the front section recording level
control is disabled.
ENABLE : Use of the front section recording level
control is enabled.
* The CH-1 recording level control on the side section
works regardless of the setting.
LOCAL
BLINK
OFF
48K
ENABLE
E-68
Setting
Value