66 EN | REMOTE CONTROL FUNCTIONS |
Remote A/B Code Switching
This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals. This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code signals. When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately.
1 | 3 | 2 |
A Set the remote control code for Remote.
APress and hold A/B.
BPress the number key “2”.
CPress STOP (8), and release A/B.
●The Remote now can transmit B code control signals.
B Check the remote control code for VCR.
Press and hold PLAY (4) on the VCR for more than
5 seconds while the VCR is turned off. The code currently set appears on the display panel.
C Change the code for VCR.
Press any key on the Remote. The VCR now responds to B code control signals.
●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the number key “1” in step B of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control code for the Remote between A and B ( step 1), keeping two VCRs to different control codes.
●To change only the remote control code for the Remote, DO NOT perform steps 2 and 3.
T | 2 | W |
1 | 3 |
2
4 5 6
7 8 9
04
1 |
|
|
| DV |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
