EN 25
G Access the DBS Receiver Brand Set screen.
Press OK or e.
H Enter the DBS receiver’s brand.
Press the appropriate number keys to enter the brand code from the following list, then press OK or e.
The program currently received through the DBS receiver appears for about 10 seconds.
BRAND NAME | CODE |
|
|
JVC (DISH Network) | 51 |
ECHOSTAR (DISH Network) | 51 |
SONY (DSS) | 41 |
RCA (DSS) | 40 |
|
|
If the DBS receiver’s channel changes to the channel listed below for your brand, setting is complete.
JVC ] 100 ECHOSTAR ] 100
SONY ] 205 RCA ] 205
Press OK or e and “DBS RECEIVER CONTROL IS ON” appears on the screen for about 5 seconds, then it returns to the normal screen.
If the DBS receiver’s channel does not change as shown above;
APress rt to move the highlight bar (arrow) to “NO”, then press OK or e.
BRepeat step 8.
NOTES:
●The Controller may not work with all types of DBS receiver.
●If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.
●The VCR can only change the satellite channel through the Controller during timer recording.
●If your DBS receiver cannot be operated with a Remote (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.
●If the VCR’s memory backup expires because of a power failure, set the cable box output channel and brand again.
●For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at
