JVC HR-J7005UM manual Turn on the TV, SET Remote Control Mode, SET TV Brand Code, Operate TV

38EN

SPECIALFEATURES

POWER

VCR/TV/CABLE/DBS					ENTER
TV/VCR
	1		2	3
					2		NUMBER
	4		5	6
	7		8	9
			0		4
	1
					PROG	+
				TV
STOP
TV					TV
				3
	PROG	–
TV

TV Multi-Brand Remote Control

The VCR's remote control can control several functions on JVC remote control TVs and on the brands of remote control TVs listed below.

TURN ON THE TV

1 Turn the power on using the TV's remote control.

SET REMOTE CONTROL MODE

2 Set the VCR/TV/CABLE/DBS switch on the VCR's remote control to TV.

SET TV BRAND CODE

3 Refer to the chart below. While holding down POWER on the VCR's remote control, enter your TV’s brand code using the NUMBER keys, then press STOP. Follow the example shown at bottom right.

Check if the TV's power goes off as it should. If it does, try other operations (☞ step 4).

●Once you have set the remote control to operate the TV, you don’t have to repeat this step until you replace your remote control’s batteries.

●GRADIENTE and PHILICO have several different codes. If the TV does not function with one code, try entering another.

OPERATE TV

4 Press the corresponding button: POWER, TV PROG +/–,

TV/VCR, TV +/–, (TV Muting) and NUMBER keys.

●For some brands of TV, you must press ENTER after having pressed the NUMBER keys.

●To return the remote to VCR control, set the VCR/TV/ CABLE/DBS switch to VCR.

TV BRAND NAME	BRAND CODE
JVC	01
GRADIENTE	05, 15, 18, 20
PHILIPS	02
CCE	02
SANYO	16
PHILICO	10, 17, 21
SHARP	06
TOSHIBA	14
MITSUBISHI	03
SAMSUNG	12
LG	18
RCA	05
PANASONIC	11
GRUNDIG	19
SONY	07
NEC	20
NOBLEX	22
HITACHI	10
DAEWOO	17

NOTE:

Depending on the kind of TV, there may be cases where some or all functions cannot be operated using the remote control.

(Ex.) To set remote control to PHILIPS 03:

POWER		STOP
0	3
		Release
Hold	Press in succession
down