40
EN
SPECIAL
FEATURES
(cont.)
DBS Receiver Multi-Brand
Remote Control
POWER | The VCR's remote control can control functions on the brands |
of DBS (Direct Broadcast Satellite) receivers listed below. |
VCR/TV/CABLE/DBS |
|
| ENTER |
|
|
| |
1 | 2 | 3 |
|
|
|
| 2 |
4 | 5 | 6 | NUMBER |
| |||
7 | 8 | 9 |
|
| 0 |
| 4 |
1
STOP
TV PROG +
TV PROG – 
3
1
2
3
4
TURN ON THE DBS
RECEIVER
Turn the power on using the DBS receiver’s remote control.
SET REMOTE CONTROL MODE
Set the VCR/TV/CABLE/DBS switch on the VCR's remote control to CABLE/DBS.
ENTER DBS RECEIVER BRAND
While holding down POWER on the VCR's remote control, use the NUMBER keys to enter the DBS receiver brand number from the chart below and then press STOP. Follow the example shown at bottom right.
Check if the DBS reciever's power goes off as it should. If it does, try other operations (☞ step 4).
●Once you have set the remote control to operate the DBS receiver, you don't have to repeat this step until you replace the remote control's batteries.
OPERATE DBS RECEIVER
Press the corresponding button: POWER, TV PROG
●Depending on the DBS receiver you may have to press ENTER after having pressed the NUMBER keys.
●To change the DBS receiver's channel, press TV PROG +/– or the NUMBER keys. (The CH +/– button can be used to change the VCR's channel only.)
●To return the remote to VCR control, set the VCR/TV/ CABLE/DBS switch to VCR.
DBS BRAND NAME | BRAND CODE |
|
|
ECHOSTAR (DISH Network) | 51 |
PRIMESTAR | 50 |
SONY (DSS) | 41 |
RCA (DSS) | 40 |
|
|
NOTES:
●Depending on the kind of DBS receiver, there may be cases where some or all functions cannot be operated using the remote control.
●Though ECHOSTAR has a number of different remote codes, this remote control is applicable only to one of those codes preset at the factory.
●It's not possible to set the remote control for both your cable box and your DBS receiver at the same time; you can only set the remote control to the brand of either one.
●You have to subscribe to a satellite broadcaster to receive DBS channels.
(Ex.) To set remote control to RCA 40:
POWER |
| STOP |
| |
4 | 0 | Release | ||
| ||||
Hold | Press in succession |
|
| |
down |
|
|
|
