4
INSTALLING
YOUR
NEW
VCR
Basic Connections
Antenna or Cable
Coaxial Cable
Flat Feeder
ANTENNA-
IN (Antenna
AC Power | Matching Transformer | or Cable | |
| input) | ||
Cord |
| ||
|
| ||
Back of VCR | RF | ||
| Video Cable | ||
| OUT | ||
AC | (not supplied) | ||
| |||
Outlet |
|
| |
Audio Cable (not supplied)
RF Cable (supplied)
75 ohm terminal
300 ohm terminal
TV
1
2
3
4
5
CHECK CONTENTS
Make sure the package contains all of the accessories listed in “SPECIFICATIONS” (☞ pg. 47).
SITUATE VCR
Place the VCR on a stable, horizontal surface.
CONNECT VCR TO TV
The connection method you use depends on the type of TV you have.
RF Connection
●To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV antenna from the TV.
b– Connect the TV antenna cable to the ANT IN jack on the rear of the VCR.
c– Connect the supplied RF cable between the RF OUT jack on the rear of the VCR and the TV’s antenna terminal.
AV Connection
●To Connect To A TV With AV Input Terminals . . .
a– Connect the antenna, VCR and TV as shown in the illustration.
b– Connect an Audio/Video Cable between the AUDIO OUT and VIDEO OUT jacks on the rear of the VCR and the AV IN jacks on the TV.
CONNECT VCR TO
POWER SOURCE
Connect the power plug to an AC outlet.
FINAL PREPARATION FOR USE
Select the VCR channel (3 or 4) by setting the switch on the rear of the VCR as shown in the illustration.
Turn on the power to the TV. You are now able to perform simple playback (☞ pg. 12) and recording (☞ pg. 13).
Back of VCR
RF OUT |
CH3 CH4 |
NOTES:
●The VCR channel is the channel on the TV which will display the audio and video signals from the VCR. The VCR's CH3- CH4 switch sets the VCR channel to CH3 or CH4.
●The
●If your TV has no AV input terminals, set the channel on the TV to correspond to the
●Even if your TV has AV input terminals, you must connect it
to the VCR using an RF cable in order to record one show while watching another (☞ pg. 26).
●For full identification of the VCR's rear panel, refer to the Index (REAR VIEW ☞ pg. 48).
