JVC HR-J770EK setup guide Or remote control until the display panel

7

PRESET DOWNLOAD

SET THE TUNER CHANNELS BY DOWNLOADING FROM YOUR TV, CLOCK AND GUIDE PROGRAM NUMBERS

When you connect the recorder and your TV via fully-wired 21-pin SCART cable (☞ pg. 5), you can set the recorder's tuner channels by downloading preset data from your TV instead of using the Auto Set Up function (☞ pg. 6). After downloading is completed, the recorder sets the clock and VIDEO Plus+ assigned Guide Program numbers automatically.

For details, refer to the instruction manual for your TV.

ATTENTION

You can use this function only with a TV offering T-V Link, etc.*

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NexTView Link via fully-wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

Before performing the following procedure, make sure that:

■the TV aerial cable is connected to the recorder and a 21-pin SCART cable is connected between your TV and the recorder.

■the mains power cord is plugged into the mains outlet.

■batteries have been installed in the remote control.

		1	Press	. If "Auto" appears on the display
			panel, Press %Þ to select "CH – –" and
			press OK or #. Preset position on the
			display panel increases from "CH1";
			do NOT press any button on the recorder		T-V LINK
			or remote control until the display panel
					PLEASE WAIT
		– –:– –	shows either the display as illustrated on
			page 8 or "– – :– –".
			● If "– –:– –" appears on the display panel, refer
			to page 8.
			● If you are using the on-screen display, the T-V
			LINK screen will appear. Then the GUIDE		[MENU] : EXIT
		– –:– –	PROG SET screen will appear during Guide
			Program number set.
1	2	3	● If you press any button on the recorder or
		2	remote control while downloading is in
4	5	6			GUIDE PROG SET
7	8	9	progress, this process will be interrupted and
			you will need to start again. See NOTES below.		PLEASE WAIT
		4
	0
1	?				[MENU] : EXIT
		2	Press	to turn off the recorder. Press
			and hold down STOP on the recorder
			until the display panel shows the display
			as illustrated on the right. Press PR – until
			the display panel shows "_OUT– –" to set
			the Video Channel to off.

3

Press OK to exit Video Channel Set mode.

To view picture signals from the video recorder, set your TV to its AV mode.

— Refer to the instructions supplied with your TV set for how to do this.

NOTES:

●In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program number set.

●If there is a power cut, or if you press or MENU while downloading or set up is in progress, it will be interrupted; be sure to turn off the recorder power once and try again from the beginning.

●Auto clock may not function properly depending on reception conditions.

●When you perform Preset Download, be sure to use fully-wired 21-pin SCART cable.

●On this recorder, the characters available for station names (ID) are A–Z, 0–9, –, *, + and (space). The names of some downloaded stations may differ from those on your TV (☞ pg. 46).