JVC HR-S6600EK setup guide Link Functions, Turn on the Recorder, NexTView Link, TV Auto Power On

T-VLINK

11

T-V Link

Functions

When you connect the recorder and your TV via a fully-wired 21-pin SCART cable (☞ pg. 6), the following functions are available. You can use these functions only with a TV offering T-V Link, etc.*

For details, refer to the instruction manual for your TV.

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully- wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

NexTView Link

You can download the EPG (Electronic Programme Guide) information from your TV for timer-programming on the recorder.

For details, refer to the instruction manual for your TV.

TV Auto Power On

You can turn on the TV and set it to video mode automatically whenever you play a tape.

For details, refer to the instruction manual for your TV.

VCR Auto Standby

You can use your TV's remote control to turn off the recorder. For details, refer to the instruction manual for your TV.

Direct Rec

You can start recording the programme that you are watching on your TV with simple operation. Press and hold RECORD and press PLAY on the remote control, or press RECORD on the recorder.

Follow the procedure below to use this function.

TURN ON THE RECORDER

1 Press		.
	ACCESS MAIN MENU
	SCREEN
2 Press MENU.
	ACCESS MODE SET
3	SCREEN
	Press %Þ to move the		MAIN MENU
	highlight bar (pointer) to
			MODE SET
	"MODE SET", then press
			AUTO CH SET
	OK or #.		MANUAL CH SET
			INITIAL SET
			[5°] =
			[MENU] : EXIT
4	SELECT DIRECT REC MODE
	Press %Þ to move the		MODE SET
	highlight bar (pointer) to		B. E. S. T.	ON
	"DIRECT REC", then press
			PICTURE CONTROL	AUTO
	OK or #to set to "ON".		AUTO TIMER	OFF
			O. S. D.	ON
			DIRECT REC	ON
			AUTO SP=LP TIMER	OFF
			POWER SAVE	OFF
			NEXT PAGE
			[5°] =
			[MENU] : EXIT
	RETURN TO NORMAL
	SCREEN
5 Press MENU.

NOTES:

●If "DIRECT REC" is set to "OFF", the RECORD button functions as described in "Recording" (☞ pg. 14) .

●During the Direct Rec, "– –" appears on the display panel.

●When you perform T-V LINK functions, be sure to use a fully- wired 21-pin SCART cable.

●Direct Rec is not possible with a scrambled broadcast.

●To record a scrambled broadcast, set "DIRECT REC" to "OFF" and follow the procedure described in "Recording" on page 14.