JVC HR-S7600EK setup guide TV Receiver Player Your recorder Recorder

36ADVANCEDOPERATIONS(cont.)

A				B
	TV Receiver	Player	Your recorder	Recorder	Your recorder	TV Receiver

	21-pin SCART Cable
VIDEO	(not provided)		21-pin SCART Cable	RF Cable
CHAN-				(provided)	VIDEO
			(not provided)
NEL or					CHAN-
	RF Cable
AV mode					NEL or
	(provided)				AV mode
	Another recorder		Another recorder
	Recorder		Player
C
TV Receiver	Recorder	Your recorder

S-Video Cable (not provided)

21-pin SCART Cable (not provided)

Another recorder

Player

NOTES:

●All necessary cables can be obtained from your dealer.

●For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

●When you select EDIT to dub tapes in step 3, be sure to select AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the tapes.

●When you use this recorder as the player for editing, be sure to set "O.S.D." to "OFF" before starting (☞ pg. 39).

●If you are using another recorder with S-Video and Audio input/output connectors, you can connect those connectors to this recorder's S-VIDEO IN/S OUT and AUDIO IN/OUT connectors.

When Using Your Video Recorder As The Source Player ...

... connect its rear panel S OUT and AUDIO OUT connectors to the recording deck's S-Video and Audio input connectors. When Using Your Video Recorder As The Recording Deck ...

... connect its front panel S-VIDEO and AUDIO input connectors to the source player's S-Video and Audio output connectors. Then, set the recorder's input mode to "S-1".