JVC HR-S7722EK, HR-S7700EK setup guide Engage Insert Editing, Start Editing, END Insert Editing

PLAY

	A
INSERT	.
	DUB

– –:– –

39

6	ENGAGE INSERT EDITING
	Press INSERT.
	● Your recorder enters the Insert-Pause mode. (" ", " "
	and " " light up on the front display panel.)
	● The TV screen changes from the still picture to the
	input source you are going to record.

START EDITING

7 Load the source cassette and play back the segment that is to be inserted. When you reach the start of the section of the source tape that you wish to insert, press PLAY to start the tape in your recorder; Insert Editing begins at this point.

●"" and "" are displayed on the front display panel.

END INSERT EDITING

8 At counter "0:00:00", Insert Editing will stop automati- cally while the tape continues running in the Play mode. If you wish to stop Insert Editing before the specified edit-out point, press 0000.

0000

1

1 2 3

2

4 5 6

7 8 9

4

0

?

FOR AV INSERT EDITING

If you want to replace the picture, Hi-Fi audio soundtrack and

normal audio soundtrack all at the same time...

... In step 6 above, after you press INSERT, press A. DUB also. ("" and "" blink and "" lights up on the front display panel.)

NOTES:

● Suitable leads can be obtained from your dealer.

● Insert editing is not possible with cassettes whose safety tab

has been removed.

PLAY

3

● When insert editing is performed on a tape that has been

recorded on another video recorder, the inserted portion may

appear distorted.

● In insert editing, the recording speed (SP/LP) is determined by

the previous recording to be replaced. If the previous

recording's speed changes within a single edit, the inserted

picture will be distorted at the switching point.

● A small portion of the recording which precedes an insert edit

may become erased.

● Insert Editing is also possible using the rear panel AV1 (L-1) IN/

OUT or AV2 (L-2) IN/DECODER connector. When using these

connectors, make sure to select the correct input mode in step

2.