JVC HR-S7722EK Enter Satellite RECEIVER’S Brand, Select Satellite RECEIVER’S Channel for Testing

[0–9]= [MENU] : EXIT

NUMBER

1

MENU

1 2 3

2

4 5 6

7 8 9

4

0

?

4

5

13

ACCESS SAT CONTROL SET SCREEN

Press %Þ to move the	INITIAL SET
highlight bar (pointer) to	CLOCK SET
“SAT CONTROL SET”,
	GUIDE PROG SET
then press OK or #.
	SAT CONTROL SET

[5°] =

[MENU] : EXIT

ENTER SATELLITE

RECEIVER’S BRAND

Press the appropriate

NUMBER keys to enter the	SAT CONTROL SET
brand code from the list in
	BRAND :	– –
the left column, then press
OK.

●If the brand code you entered is invalid, the

SATELLITE TUNER BRAND	CODE
JVC	73
AMSTRAD	60, 61, 62, 63, 92
CANAL SATELLITE	81
CANAL +	81
D-BOX	85
ECHOSTAR (VIA DIGITAL)	82
FINLUX	68
FORCE	89
GALAXIS	88
GRUNDIG	64, 65
HIRSCHMANN	64, 78
ITT NOKIA	68
JERROLD	75
KATHREIN	70, 71
LUXOR	68
MASCOM	93
MASPRO	70
NOKIA	87
PACE	65, 67, 74, 86, 92
PANASONIC	74
PHILIPS	66, 84
RFT	69
SAGEM	83
SALORA	68
SIEMENS	64
SKYMASTER	69
TPS	83
TRIAX	91
WISI	64

NOTES:

●The Satellite Controller may not work with all types of satellite receiver.

●For some satellite receivers, you need to set its channel input mode to 2-digit.

●If your satellite receiver has more than two channel mode, be sure to set to "All Channel Mode". For details, refer to the instruction manual of the satellite receiver.

●When selecting the satellite receiver's channel (☞ step 6), signals from the remote control may interfere with signals transmitted from the Satellite Controller. In this case, move the remote control as close to the recorder's infrared beam receiving window as possible.

6

7

code field is reset. Enter the correct brand code again.

●If the recorder is in playback or recording mode, you cannot set the brand code.

SELECT SATELLITE RECEIVER’S CHANNEL FOR TESTING

Press the appropriate	SAT CONTROL SET
NUMBER keys to enter
one of the channel	SAT PROG :
		– – –
positions on the satellite
receiver, then press OK.

●You can select the

channel position
	[0–9] = : TEST
between 1 to 999.	[MENU] : EXIT

●After pressing OK, the recorder enters the Test mode.

CHECK RESULT OF TEST

If the satellite		SAT CONTROL SET
receiver’s channel		SAT PROG : 111
number has been
changed to the same		CHANGED TO 111
channel as you set in		NOT CHANGED
step 6...
Press %Þ to move the
	[5°] =
highlight bar (pointer) to	[MENU] : EXIT
“CHANGED TO ...”, then
press OK or #to finish the
Sat Control Set mode.

If the satellite receiver’s channel number has not

been changed correctly...

Press %Þ to move the highlight bar (pointer) to “NOT CHANGED”, then press OK or #. Then perform the procedure again from step 5.