JVC HR-S7900U manual 24HR Quick, 36 EN, Access 24HR quick program display, Set program start time

36 EN		TIMER RECORDING (cont.)
24HR Quick	made as far as a year in advance. Remember, the clock
	You can program a timer recording that starts within
Programing	24Ê hours. Up to 8Ê timer recording programs can be
	must be set before you can program the timer (☞Ê pg.Ê 8
	orÊ 10).
		Load a cassette
JOG dial	1 Make sure the record safety tab is intact. If not,
		cover the hole with adhesive tape, then load it
		into the VCR.
		● The VCR turns on, and the counter is reset,
		automatically.

					REW	FF		Access 24HR quick program display.
					PLAY
								2 Push 24HR QUICK PROGRAM
POWER					–		+
S VIDEO	VIDEO (MONO)L—AUDIO—R	REC LINK		A.DUB	24HR QUICK		CH– /+		. “	” and start
							PUSH / TURN
					PROGRAM			time start blinking on the display panel.
		DIGITAL TBC/NR	SP EP	INSERT
			VCR		REC	PAUSE STOP/EJECT
								Program start time indicator
				24HR QUICK
				PROGRAM

NOTES:

●If “Err” appears on the display panel, repeat the steps again.

●When a menu screen is shown, you cannot use 24HR quick programing function. Press MENU to return to normal screen, and try again.

●You can use 24HR quick programing function also when the VCR is turned off.

●For 24HR quick programing function, the program overlap warning display does not appear even if some programs overlap each other.

●Even if a power failure occurs, the VCR keeps your timer programs. However, the clock time, channel settings, and other menu settings are lost.

As a result, when the power is supplied again to this VCR after the power failure, the following will take place.

1.This VCR starts the Plug & Play setting automatically to restore the clock time and channel setting.

2.If the clock time and channel setting are restored correctly, each timer program you have made will start at its start time unless its end time has elapsed.

Timer warning display

3Set program start time

Turn the JOG dial to the left or right. Then, push the JOG dial. “” and start time start blinking on

the display panel.

Program start time indicator

●One click stop of the JOG dial changes the time in 5-minute intervals.

4Set program stop time

Turn the JOG dial to the left or right. Then, push the JOG dial and channel number will start

blinking. Program stop time indicator

●One click stop of the JOG dial changes the time in 5-minute intervals.

5 Set channel number

Turn the JOG dial to the left or right.

A warning appears on the TV screen to tell you that the timer-recording is to start in 5Ê minutes if you are not in the timer recording standby mode at that time. Press TIMER to put the VCR into timer recording standby mode. To clear CANCEL on the Remote.

–WARNING–

TIMER RECORDING

TO START SOON (CANCEL)

the display, press

●You can cancel the setting at any time by pressing and holding the JOG dial for more than 3 seconds. Repeat from the step 3.

6Engage timer recording standby mode

Press 24HR QUICK PROGRAM .

The VCR turns off automatically and “ä” is displayed on the front display panel.