EN 47
You can use a camcorder as the playback VCR and your VCR as the recording VCR
1 Make connections
Connect an audio/video cable between the camcorder’s audio/video output connectors and your VCR’s audio/video input connectors.
●When the JVC camcorder is equipped with the Master Edit Control, you can control the VCR from the camcorder. Connect the
●When using a camcorder with a monaural output, connect the audio output connector on the camcorder to the left audio input connector on this VCR.
2 Load a cassette
Insert the cassette to be recorded on into this VCR (for recording).
3 Select input mode on this VCR
Select
Select
On the front panel:
Push the JOG dial, then turn it to the left or right.
On the Remote:
Press the Number key "0 (AUX)" and/or CH
4 Select video input terminal
Follow the procedure described on pages 39 and 43.
When using S VIDEO terminal, set “FRONT AUX INPUT” (or “REAR AUX INPUT” if you use the connectors on the rear) to
When using VIDEO terminal, set “FRONT AUX INPUT” (or “REAR AUX INPUT”) to “VIDEO”.
5Set “PICTURE CONTROL” to “EDIT”
Follow the procedure described on pages 39 and 40.
If your camcorder is a JVC Master Edit Control- equipped type — go to step 6.
If your camcorder is NOT a JVC Master Edit
6Set “AV COMPU-LINK” to “OFF”
Follow the procedure described on pages 39 and 42.
●The REMOTE PAUSE/AV
7Return to normal screen
Press MENU.
8StartSet theplaybackcamcorder to its play mode.
NOTE:
If the camcorder is equipped with a superimpose/OSD disable feature then set it to “OFF” before starting playback.
9Start recording
On the front panel:
Press REC ( ¦ ).
On the Remote:
Press REC ( ¦ ) and PLAY ( 3 ) at the same time.
●If you are using a Master Edit
NOTE:
Be sure to select “AUTO” for “PICTURE CONTROL” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes (☞ pg. 39 and 40).
