JVC HR-S7900U manual Entire program while timer-recording in SP mode, For Example

					EN 41
			* The default setting is bold in the table below.
⬛ AUTO SP = EP TIMER	When this function is set to “ON”, the VCR automatically switches to EP
ON	mode to allow complete recording if there is not enough tape to record the
OFF	entire program while timer-recording in SP mode.
	For Example . . .
	Recording a program of 140 minutes in length onto a 120-minute tape
		Approximately 110 minutes		Approximately 30 minutes
		SP mode		EP mode
	Make sure you set this function to “ON” before the timer-recording starts.
	NOTES:
	● If you have programed the VCR to timer-record 2 or more programs, the second
	program and those thereafter may not fit on the tape with this function set to "ON". In
	this case, do not use this function, but change the tape speed manually during timer
	programing.
	● In order to ensure that the recording fits on the tape, this function may leave a slight
	non-recorded portion at the end of the tape.
	● There may be some noise and sound disturbance where the tape speed switches from
	SP to EP mode on the tape.
	● This function is not available during ITR (Instant Timer Recording), and will not work
	properly on the following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
⬛ DIGITAL R3	When this function is set to “ON”, edge correction to the luminance signal is
ON	performed to enhance details. Normally set this function to “ON”.
OFF	NOTES:
	● Depending on the type of tape being used, picture quality may be better with
	“DIGITAL R3” set to “OFF”.
	● If you use this VCR as the playback VCR for editing, be sure to set “DIGITAL R3” to
	“OFF” before starting.
⬛ VIDEO STABILIZER	When this function is set to “ON”, you can automatically correct vertical
ON	vibrations in the picture when playing back unstable recordings made on
	another VCR.
OFF
	NOTES:
	● When you finish viewing a tape, be sure to set this function to “OFF”.
	● Regardless of the setting, this function has no effect during recording and during
	special effects playback.
	● The on-screen display may jitter vertically when this function is set to “ON”.
	● To watch recordings with close-caption, set this function to “OFF”.
⬛ BLUE BACK	When this function is set to “ON”, the TV screen becomes all blue in the
ON	following cases:
	● When receiving a channel not in use.
OFF
	● When stopping playback.
	NOTE:
	When you want to receive an unstable channel with poor signals, set this function to
	“OFF”.
⬛ 2ND AUDIO RECORD	When this function is set to “ON”;
ON	● If a SAP program is received, the SAP audio is recorded on both the normal
	and Hi-Fi tracks. The main audio is not recorded.
OFF
	● If a non-SAP program is received, the main audio is recorded on both the
	Hi-Fi and normal tracks.
	When this function is set to “OFF”, the SAP audio cannot be recorded.

Refer to page 39 for setting procedures.