JVC HR-S7955EK manual Three-Step Quick Start, Auto Setup, Is vacant and have set the VCR to

three step quick start

11

Three-Step Quick Start

For Step , be sure to perform either of the methods: Auto Setup or Preset Download.

Auto Setup

before you start

Check that the VCR is turned off and no cassette is inserted

Load the batteries into the Remote Control

START AUTO SETUP

Press the obutton.

what will happen? The display panel on the front of the VCR will show the word ‘Auto’. Do not press any button on the VCR or the Remote Control. note If you have connected both the RF cable and the fully-wired 21-pin SCART cable, and if your TV offers T-V Link, etc., and the TV is turned on, the VCR automatically performs the Preset Download (
pg. 11) even if you select ‘Auto’ for Auto Setup function.

Refer to the Remote Control diagram on pages 6–7

Auto Setup is running: don’t

The VCR is automatically setting up the tuner

channels, clock, the VIDEO Plus+ system assigned Guide Program numbers and the video channel. This only happens the first time that the VCR is turned on.

Unless indicated	touch any buttons
otherwise, use the
buttons on the Remote
Control	AUTO SET
	PLEASE WAIT
Check that the
connection is completed	[MENU]: EXIT

rf and scart connection If you have chosen to connect the VCR to the TV with both the RF Cable and a 21-pin SCART Cable (not provided) and the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:

			Turn on the TV
				ENTE
							R/E
							NT
								R
								E
						3	OK /	E
				PR
							+
O	– –:– –
				TE			PR
		TV
			TV/VCR	AUDIO		– –:– –
		1 . , /	2 ABC			3 DEF
							2
		4GHI	5 JKL			6MNO
		VPS/PDC	DAILY/QTDN. WEEKLY/HEBDO
		7PQRS	8TUV			9WXYZ
		0000	AUX				4
			0
		START	STOP	DATE		PR
		DEBUT	FIN
			EXPRESS
	1	PROG	?			30 SEC
				ENTER/ENTREE
		MENU		3	OK /
			TV PR		+
		T				+
		V
		–				TV
			TV	PR	–
			LP00000-000

VCR/ TV

Your TV screen during Auto Setup if SCART is used

SELECT THE VIDEO CHANNEL

When Auto Setup has finished, you will see the following display panel on your VCR:

rf cable only If you have only used the RF Cable to connect the VCR to the TV, you will

see this display. The number is the channel on the TV that the Auto Setup has chosen to be the video channel. In the example, we have presumed that channel

36 is vacant and have set the VCR to 36:

Now tune the TV set to channel 36 (refer to TV manual if necessary); you should see two vertical white bars appear on the TV screen. If the bars do not appear or are not clear, choose another vacant channel pressing PR button on the Remote Control and try again. If you cannot obtain the vertical white bars on any channel between 22 and 69,

consult your local JVC dealer.

rf and scart connection If you have chosen

to connect the VCR to the TV with both the RF

Cable and a 21-pin SCART Cable (not provided), you need to press the PR button on the Remote Control until the figure reads ‘– –’. This is because you will use the TV in AV mode to view video pictures and therefore do not need a dedicated video channel.